|
|
 |
 |
 |
|
NEWS & EVENTS
Introducing the OM1005 Ethernet Switch
Gigabit ethernet switch - 4 port 10/100/1000BASE-T and 1 port 1000BASE-X SFP
April 1, 2011
The OM1005 Ethernet switch has four 10/100/1000BASE-T electrical ports, and one optical SFP port. The optical port is switch configurable to 100BASE-FX and 1000BASE-X; this allows the optical network port to be upgraded to a higher speed. The SFP type (multimode, singlemode, and single fiber) is specified at the time of ordering, and can be seen on the sticker on the base of the unit (see Ordering Information). A signal strength bar graph shows the received optical power. The Ethernet and power connectors are on the front side for easy access. A rear dip switch enables manual configuration. The power input accepts 5 to 30 VDC input from an external power cube (supplied). A secondary power supply connection is available on the rear of the case. The OM1005 is enclosed in a rugged metal case for low radiated and conducted emissions.
Features
- 5 Year warranty
- SFP optical interface
- Supports jumbo packets
- Single, multimode, or single bidirectional fiber operation
- Built in optical power display
- Distances up to 100 km
- DIN rail mounting option
- Auto or manual configuration
- Redundant power supply inputs
- Plug and play or force mode operation
More Power over Ethernet
Luxcom Technologies expands its product diversities!
September 16, 2008
Here we grow again, with a new product offering based on our proven PoE technology; the OM1000P power over ethernet media converter. The OM1000P media converter has one optical and one electrical port. It primarily connects a 1000BASE-T Ethernet device to a 1000BASE-X fiber optic Local Area Network over a pair of optical fibers; however a switch setting also allows it to connect a 100BASE-TX electrical port to a 100BASE-FX optical network. The transceiver architecture is not switch based; therefore the unit transmits the data as it is received with only a few bits of delay. The OM1000P can supply 48 Volts to attached equipment for PoE applications. The optical I/O uses an SFP pluggable interface that supports a variety of modules. Auto-negotiation provides plug-and-play operation on the electrical and optical ports. Alternately the unit may be manually configured for MDI/MDI-X and full/half duplex operation. A serial port allows performance and configuration monitoring.
Features
- 5 Year warranty
- SFP optical interface
- Supports 10KB jumbo packets
- Heavily shielded case
- Supplies power for PoE applications
- Diagnostic monitor port
- IEEE 802.3ah compatible
- Auto or manual configuration
- Internal power supply
- Link failure pass through
|
|
